Industrial Disposal Supply is proud to offer the DuraTech 2009 Tub grinders in a new stationary model. The versatile 2009 Tub grinder is now available with electric motor drives. A 400 hp soft start main drive motor as well as a 75 hp motor to power the hydraulic system are available in various voltages to fit your power grid specifications. These Electric motors provide steady power with no emissions, little maintenance, and reduced noise levels. The PT Tech Torque limiter protects the motor and hammermill from overloads, and costly repairs. The stationary units are available as skid mounted units or as a mobile unit with a pintle hitch.

Additional Information

  • Motor-Tub Drive 400hp/380V/60HZ- South Korea Only
  • Motor-Hydraulic drive 75hp/380V/60HZ- South Korea Only
  • Motor-Tub Drive 400hp/380V/50HZ
  • Motor-Hydraulic drive 75hp/380V/50HZ
  • Motor-Tub Drive 400hp/4600V/60HZ
  • Motor-Hydraulic drive 75hp/460V/60HZ
  • Hydraulic Oil Capacity 50 Gallons (189.3 Liters)
  • Tub Governor Electro-Hydraulic Sensing
  • Tub Speed Sensor Magnetic Sensor
  • Tub Width 9’ 6-3/8” (2.91 m) at Flare
  • Tub Depth 40” (1.02 m)
  • Tub Diameter at Base 7’ 6” (2.27 m)
  • Tub Wall 3/16” (.476 cm) Thick
  • Tub Floor 1/4” (.635 cm) Thick
  • Tub Drive Hydraulic Orbit Motor
  • Safety Switches Tub Tilt in relationship to Hammermill operation
  • Belly Conveyor 30” (76.2 cm) Wide
  • Discharge Conveyor 21’ 6” (6.55 m) Top Drive L- 24” (60.96 cm) Wide
  • Hammermill Opening 41” x 25” (104.14 cm x 63.5 cm)
  • Hammermill Drive Belt and pully through Torque Limiter
  • Rotor Length 40” (101.6 cm)
  • Rotor Plates 16” (40.64 cm) in Diameter 1” (2.54 cm) Thick
  • Rotor – Shaft Diameter 4-1/2” (11.43 cm) Stress Proof Steel
  • Bearings 3-1/2” (8.89 cm) Pillow Block Bearings
  • Hammer Rods 1-1/2” (3.43 cm) Diameter
  • Hammers 20 Fixed Single Bolt, or 40 swinging hammers
  • Screens 1” (2.54 cm) Thick Split Screens
  • Screen area 2,240 Sq in (14,451.6 sq cm)